PEAVEY VALVERB

Technic details

Specifications

Type:	Pre Amplifier and Spring Reverberator / Optical Tremolo
The fallowing specifications are measured at 1kHz with the controls preset as follows:	Drive set at 6.5 Speed set at 1 Intensity set at 1 Bass set at 6.5 Mid set at 6.5 Treble set at 6.5 Mix set at 50% rotation Volume set at 6.5

[Input]	Impedance: 500kΩ (Very high Z) Nominal input level: -6 dBV (500mV RMS) Minimum input level: -26 dBV (50mV RMS)
[Output]	Load impedance: 33kΩ or greater Nominal output: +0 dBV (1V RMS)
Remote Footswitch:	Special 20button unit (Supplied) System Hum and Noise at Nominal Level: Greater than 75dB below rated power (20Hz to 20kHz)
Equalization:	Custom Low, Mid, and High passive type EQ (Reverb only)
[Front Panel Controls]	Input Jack (6.3mm) Drive Tremolo: Speed Intensity Reverb: Bass Mid Treble Mix Master Volume Power Switch On / Off
[Rear Panel Jacks (6.3mm)]	Input Output Remote Switch
Tube Complement:	12AX7 x 2 12AT7 x 1