Intermodulation distortion ratio (60 Hz to 7kHz = 4: 1): | Phono MM 1, 2, MC - 0.002% or less (Rec Out: 145mV)
Tuner, AUX 1, 2 - 0.002% or less (Pre Out: 1V)
Monitor 1, 2, 3 - 0.002% or less (Pre Out: 1V) |
Frequency response: | Phono - 20Hz to 20kHz, ±0.2dB
Tuner, AUX - 1Hz to 150 kHz, - 0.5dB
Monitor - 1Hz to 150kHz, -0.5dB |
Input sensitivity (Pre Out: 1V): | Phono MC - 220μV (When using LUX transformer 8020)
Phono MM 1, 2 - 2.2mV
Tuner, AUX 1, 2 - 145mV
Monitor 1, 2, 3 - 145mV |
Input impedance: | Phono MC - 20Ω to 40Ω (When LUX transformer 8020 is used)
Phono MM 1 - 50kΩ
Phono MM 2 - 100Ω, 50kΩ, 100kΩ
Tuner, AUX 1, 2 - 60kΩ
Monitor 1, 2, 3 - 60kΩ |
S / N ratio (IHF-A, Input short circuit): | Phono MC: 78dB (when using LUX transformer 8020)
Phono MM 1, 2 - 80dB
Tuner, AUX 1, 2 - 100dB
Monitor 1, 2, 3 - 100dB |
Tone control: | LUX method NF type Curved point with frequency switching (Bypassable) |
Low frequency bending point: | 55Hz / 77Hz / 110Hz / 155Hz / 220Hz / 310Hz / 440Hz / 620Hz / 880Hz |
High frequency bending point: | 440Hz / 620Hz / 880Hz / 1.2kHz / 1.7kHz / 2.5kHz / 3.5kHz / 5kHz / 6kHz |
Change amount: | -8dB, -4dB, -2dB, -1dB, 0dB, 1dB, 2dB, 4dB, 8dB |
Subsonic filter: | 6dB / oct., 10Hz / off / 20Hz
12dB / oct., 10Hz / off / 20Hz
18dB / oct. for both filters on |
High cut filter: | 6dB / oct., 9kHz / off / 15kHz
12dB / oct., 9kHz / off / 15kHz
18dB / oct. for both filters on |
Ancillary equipment: | MM - 2 capacitance switching (50pF, 100pF, 300pF)
Three tape monitors
Tape dubbing
Low boost switch (50Hz / off / 100Hz) |
AC outlet: | Switched - 2 lines, total 900W
Unswitched - 4 lines, total 200W |