Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco
Item Lorem ipsum dolor sit amet. Item Lorem ipsum dolor sit amet. Item Lorem ipsum dolor sit amet.
Item Lorem ipsum dolor sit amet. Item Lorem ipsum dolor sit amet. Item Lorem ipsum dolor sit amet.
Item Lorem ipsum dolor sit amet. Item Lorem ipsum dolor sit amet. Item Lorem ipsum dolor sit amet.
Technic details
Specifications
Type:
Dual Channel Power Amplifier
Output Power:
35W per channel minimum RMS (Both channels operating, into 8Ω, 20Hz to 20kHz at rated RMS, 0.05% THD)
30W per channel RMS (Both channels operating, into 8Ω, 5Hz to 30kHz, ±1dB)
Power at Clip Point:
Typically 41W RMS into 8Ω per channel
Typically 64W RMS into 4Ω per channel
Total Output (1HF):
Typically 104W RMS into 8Ω
Typically 165W RMS into 4Ω
I.M. Distortion:
Less than 0.05% from 0.01W to 30W RMS into 8Ω
Less than 0.01% at 30W RMS
Typically below 0.02%
0.03% respectively
Total Harmonic Distortion:
Below 0.05% at 30W into 8Ω
Damping Factor:
Greater than 200 (Zero to 1kHz into 8Ω)
Hum and Noise:
106dB below 30W RMS output (Unweighted band limited 20Hz to 20kHz)
115dB typically
Slewing Rate:
6V / µs
Load Impedance:
4Ω or greater
Input Sensitivity:
0.75V ±2% for 30W into 8Ω
Input Impedance:
25kΩ
DC Output Offset:
10mV or less
Load Protection:
Short, mismatch, and open-circuit proof. V-I limiting is instantaneous with no annoying thumps, cutout, etc.
Chassis:
Aluminum chassis construction for maximum heat conduction and minimum weight
Controls:
Two input level controls on front panel with power switch and pilot light
Power Supply:
AC 120V or 240V ±10%, 50Hz to 400Hz
Power Consumption:
15W or less on Idle
120W at 60W output into 8Ω
Dimensions (W x H x D):
432 x 4.4 x 222mm
Weight:
4.54kg
Buy this model
You can make a purchase request for this model. Our funds often hold several copies of each model. We are ready to consider any request and offer you our price.
